Metal roofing
Architectural shingles
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Why Austin Homeowners Choose GAF Roofing
GAF is the largest roofing manufacturer in North America, and its Timberline HDZ architectural shingle covers more Austin roofs than any other single product. We’re Crestview Roofing Co Austin, an independent GAF service provider – not a factory-authorized dealer, not a corporate installer. We repair, replace, and maintain GAF roofs across Austin every week, and we do it with rigorous attention to how GAF’s specific products fail in this specific climate. Whether it’s Timberline HDZ shingles on a 2007 tract home in Milwood or EverGuard TPO on a flat commercial deck, we know the products, the failure modes, and the honest fix. Call (254) 587-6371 for a free GAF roof estimate in Austin, TX.
Not every roofing company bothers to learn the difference between a Timberline HDZ and a Timberline UHDZ. We have to. Austin’s climate punishes GAF products in ways the manufacturer’s spec sheets don’t always anticipate – UV degradation from three straight months of 100°F sun, hail impacts that total roofs overnight, and oak tannin runoff that eats valley metal faster than anywhere else in the state. Our techs trained specifically on GAF installation tolerances and tear-off sequences, from Timberline HDZ nailing strips to low-slope TPO heat welding. That means we match the roof system’s rated performance without being tethered to a factory schedule.
Key takeaways:
- We’re an independent GAF service provider serving Austin – not affiliated with or authorized by GAF, and we’re upfront about that.
- We use genuine GAF accessories like Seal-A-Ridge, Cobra ridge vent, and StormGuard leak barrier, but we’ll substitute proven aftermarket metal flashings when it makes sense.
- Every GAF repair carries our 365-Day Done Right Promise, in writing, included on every job.
- We give you a written price before any work starts. The number on the page is the number on the invoice.
- Call (254) 587-6371 for a free estimate on any GAF roof in Austin.
Why Trust Crestview Roofing Co Austin for Your GAF Roofing?
Here’s the thing about GAF roofs in Austin: the product is good. The installation is what usually isn’t. We’ve spent years untangling shoddy installs – shingles nailed outside the nailing strip, valley metal that wasn’t set in the right order, TPO seams welded by someone who treated a heat gun like a hair dryer. Our techs don’t just fix the visible problem; they look for the install error behind it. That’s the difference between a patch that lasts six months and a repair that gets a 365-day written guarantee.
Dylan Pace, our owner, learned roofing at Los Angeles Trade-Technical College and has spent the better part of two decades on everything from steep residential pitches to flat commercial decks. He’s the one who built Crestview around a habit he picked up early: putting the scope, the timeline, and the price in writing before a single nail goes in. That’s not a marketing line – it’s how we run every job, including GAF service in Austin. If it’s not in writing, it’s just a conversation.
Background-checked, uniformed technicians. A live person answering calls 24/7. Before-and-after photos of every job. A trackable arrival time so you’re not sitting in a four-hour window. And a 365-Day Done Right Promise: if the repair fails within a year, we return and make it right – no charge, no negotiation, no runaround.
Styles & brands we work with
Common GAF Roofing Problems We Fix in Austin
GAF makes solid products. Austin makes them fail in predictable ways. Here’s what we see most often:
- Timberline HDZ nail strip misalignment. The HDZ line has a pre-printed nailing strip on the shingle’s face. When a crew ignores it and nails blind, shingles blow off in microbursts – and Austin gets plenty of those in spring. We find entire slopes where every third shingle is nailed outside the strip. The fix is methodical: lift the affected courses, inspect the strip placement, re-nail correctly, and secure with a proper sealant bead.
- Chalky granule loss on sun-exposed slopes. Austin’s UV index is brutal, and it doesn’t just fade shingles – it bakes the asphalt until the surface granules release into the gutter. You’ll see a chalky film on your hands after touching the shingle. In most cases, the shingle still has life, but it’s lost protective mass. We document the extent and give you an honest read: repair localized damage now, or plan for replacement within a defined window.
- Improperly torched EverGuard TPO seams separating at parapet walls. Flat and low-slope roofs in Austin’s commercial and modern residential builds often use GAF EverGuard TPO. The seams are heat-welded, and if the installer torched too fast, the weld fails. Water pools at the parapet and finds the seam. The repair requires a probe test to map the failed weld, then re-welding with correct temperature and roller pressure – not just slapping peel-and-stick over the gap.
- Valley metal corrosion from oak tannin runoff. Austin’s live oaks drop tannins that pool in roof valleys and eat through galvanized valley metal in five to eight years. This is Austin-specific, and it’s expensive if ignored. We replace the valley with either GAF-compatible metal or a proven aftermarket aluminum, properly underlain with StormGuard leak barrier.
- Plumbing vent boot failure on Timberline roofs. The rubber collar around plumbing vent pipes stiffens in Austin’s heat, cracks, and lets wind-driven rain in. On a 2007 Timberline HDZ roof near Loop 360, our tech found rain entering around a vent boot whose collar had hardened to plastic-brittle. We replaced it with a longer-neck Bullfrog style boot, re-flashed the area with StormGuard membrane, and confirmed zero leaks with a simulated runoff test.
GAF Parts & Our Repair-vs-Replace Approach
We use genuine GAF accessories where compatibility matters: Seal-A-Ridge ridge cap adhesive, Cobra ridge vent, StormGuard leak barrier. These are the components GAF’s warranty expects to see, and substituting cheap generics is how you void coverage and shorten the roof’s life. But we’re also honest when aftermarket makes sense. Proven aftermarket metal flashings – valleys, drip edge, pipe collars – often outperform OEM at a better price, and a good roofer knows when to use each.
What we stock locally for GAF work in Austin: Timberline HDZ shingles in the most common Austin colors (Weathered Wood, Charcoal, Barkwood), Seal-A-Ridge, StormGuard leak barrier, Cobra ridge vent, pipe boot assemblies, and valley metal. That means most GAF repairs don’t wait on a supplier order.
Repair or replace? We inspect the decking first, every time. If the sheathing is delaminating from Austin heat and humidity, re-shingling over it is malpractice. We’ll recommend replacement and show you photos of why. For our Roof Repair services, we tell you plainly if you’re buying five more years or fifteen. Call (254) 587-6371 for an honest read on your GAF roof.
Our GAF Service Process – Step by Step
- 1
Diagnosis. We get on the roof, inspect the GAF system as a whole – not just the spot where water is entering – and check the nailing pattern, the flashing condition, the valley construction, and the decking. You get photos of everything we find.
- 2
Written quote. The price is on paper before any work starts. The number on the quote is the number on the invoice. No change orders because we actually looked first.
- 3
Repair or install. We match GAF materials and install methods. Shingle replacement follows the correct nail-strip alignment. Leak repair starts at the source, not the stain. Valley repair gets full StormGuard underlayment, not just new metal over old rot.
- 4
Test. We simulate water flow with a hose, check for nail pops, and document the finished work with photos.
- 5
Warranty. Every GAF repair carries a written 365-Day Done Right Promise. Fails within a year? We return, free. Your digital invoice arrives by text before we leave the driveway.
See the difference
Before
After
Before
After
Before
AfterGAF Products We Service & Install in Austin
We work on the full GAF product range common in Austin:
- Timberline HDZ shingles – GAF’s flagship architectural shingle, the most-installed shingle in America and on Austin tract homes.
- Timberline UHDZ shingles – the thicker, higher-definition architectural line. More mass, more shadow line.
- Timberline AS II shingles – multi-width architectural, common on higher-end Austin builds.
- EverGuard TPO membrane – GAF’s thermoplastic single-ply system for flat and low-slope roofs, common on Austin commercial and modern residential.
We stock Timberline HDZ in Austin’s most common colors, plus Seal-A-Ridge, StormGuard, and Cobra. If you need a less common GAF product, we order it same week.
We Also Service These Brands
GAF is a lot of what we see in Austin, but it’s not everything. We also repair and install Owens Corning and CertainTeed roofing systems, and we can work with the industry’s top shingle brands – IKO, Atlas, Tamko, and Boral included. If you’re not sure what’s on your roof, call us. We’ll tell you what it is, what it needs, and what it costs. No brand loyalty required.
FAQs – GAF Roofing Service in Austin
No, and we say that plainly. We are an independent GAF service provider, not a GAF-authorized contractor or factory dealer. You get honesty about what that means: we’re not bound by a factory schedule or upsell targets, and we can recommend any fix that’s right for your roof, not just the one GAF’s program would push. We use genuine GAF materials and follow GAF installation tolerances because that’s what the product requires – not because a dealership agreement tells us to.
Yes, where it matters for warranty and performance. Seal-A-Ridge, Cobra ridge vent, StormGuard leak barrier, and Timberline shingles themselves are always genuine GAF. For metal flashings – valleys, drip edge, pipe collars – we’ll use either GAF-compatible metal or a proven aftermarket product, depending on cost and lead time. We’ll tell you which is which and why before we order anything. Call (254) 587-6371 and we’ll walk you through the parts list on your quote.
Most GAF repairs in Austin run half a day to a full day: shingle replacement, vent boot replacement, valley repair, flashing work. A full reroof with GAF Timberline HDZ typically runs 2 to 4 days depending on decking condition and roof complexity. We’ll give you a written schedule with the quote, not after. And your trackable arrival time updates on the day of service so you know exactly when we’re pulling into the driveway.
Timberline HDZ, Timberline UHDZ, Timberline AS II, and EverGuard TPO. In practice that covers the vast majority of GAF roofs in Austin, from 1980s composition remodels to modern flat-deck TPO installs. We stock HDZ shingles locally in Austin’s most common colors so repairs don’t wait on freight.
Only if the service itself is done wrong. GAF’s material warranty covers manufacturing defects, and using genuine GAF accessories for the repair doesn’t void it – if anything, it preserves your position. That’s exactly why we use Seal-A-Ridge, StormGuard, and Cobra. If you’re unsure what’s on the roof or what warranty applies, call (254) 587-6371. We’ll check the material type, document the repair, and make sure you keep whatever warranty coverage you actually have.
Most GAF roof repairs in Austin run $350 to $1,800 for the common stuff: vent boot replacement, valley repair, flashing repair, localized shingle replacement. A full GAF Timberline HDZ reroof on an average Austin home runs $9,000 to $16,000 depending on decking condition, roof complexity, and whether we’re replacing the underlayment properly. The price you get is written, up front, and fixed. Call (254) 587-6371 for a free estimate – we’ll put the number in writing before any work starts.
Look at the shingle’s face – Timberline HDZ has a clearly printed nailing strip running horizontally about an inch above the keyway. If the original installer nailed above or below that strip, you’ll often see visible nail heads, lifted shingle tabs, or shingles that slide slightly when you run a flat palm across them. In heavy wind, those shingles blow off first. Call (254) 587-6371 and we’ll do a nail-pattern inspection before you lose a shingle in the next Austin spring storm.
Valley leaks after heavy rain usually mean one of two things: the valley metal itself has corroded through – Austin’s oak tannin runoff accelerates this – or the underlayment beneath the valley was never properly lapped. In both cases, the leak only shows during heavy, sustained rain because lighter rain evaporates before it penetrates. The fix is a proper valley rebuild with new metal and StormGuard underlayment. Call (254) 587-6371 and we’ll diagnose it with a hose test, not a guess.
A split TPO seam can often be repaired – if the membrane around it is still in good condition. We probe-test the seam to map where the weld failed, then re-weld with the correct heat and roller pressure. If the membrane itself is brittle or punctured, you’re looking at section replacement. We’ll show you photos of either path and put the price in writing before you choose.
Some granule loss is normal, especially in the first year. But if you’re seeing gutter load after gutter load every season, Austin’s UV has likely accelerated the shingle’s aging. Granule loss exposes the asphalt underneath to direct sun, which shortens the shingle’s life. We can assess the slope, measure remaining granule density, and tell you whether you need a repair now or a replacement in a defined window. The assessment comes with photos and a written quote. Call (254) 587-6371.
You don’t reroof over delaminated decking. You replace the decking. Austin’s humidity cycle – hot, wet summers and dry winters – causes OSB and plywood to swell and break down, and shingles nailed into delaminated decking won’t hold. We’ll remove the affected sheets, replace with code-grade decking, and only then install the new GAF underlayment and shingles. It’s more upfront cost, but the alternative is a roof that fails from the substrate up. We’ll show you the delamination in photos before we quote it.
Book Your GAF Service in Austin, TX
If you have a GAF roof in Austin that needs attention – a leak you can’t find, shingles blowing off in the spring wind, or a deck that’s finally giving up – call (254) 587-6371. We’ll put the scope, the schedule, and the price in writing before anything gets touched. Free estimates, live arrival times, and a 365-day written warranty on every repair. That’s how we do Gaf in Kyle and across the Austin area.
Written by Dylan Pace, Owner at Crestview Roofing Co Austin, serving Austin since 2000.